How do I wire the trigger/input signals with a
common neutral?
A short guide on how to wire the tigger/input signals for your Nexus unit with a common neutral connector
Step 1
The Trigger Signals are located inside the unit on the right side board. If you are looking to wire Common Input trigger signals with a Common Neutral use the 2 way connector and 9 way A rail shown here.
Step 2
Wire the Common Neutral into the two way and connect your Trigger Connections into slots 1-8 in the 9 way connector as required.
Step 3
Place the Common Neutral connector back into the two way slot shown below.
Step 4
Connect any common trigger signals into the A rail as shown.
Step 5
Confirm that the Dip switches are in the BOTTOM position for the Common Neutral.
Keywords
– Wiring the trigger
– Wiring the input
– Trigger
– Signal
– Common