Nexus – How do I wire the trigger/input signals with an
isolated neutral?
A short guide on how to wire the tigger/input signals for your Nexus unit with a common isolated connector
Step 1
The Trigger Signals are located inside the unit on the right side board. If you are looking to wire Isolated Input trigger signals with a Isolated Neutral‘s use the 9 way A & B rail shown here.
Step 2
Wire both the A & B rail connectors with the trigger signal and corresponding isolated neutral connector, the trigger number and neutral highlight below. For example:
Trigger connector slot 1 neutral is slot 1 on the B rail.
Trigger connector slot 3 neutral is slot 3 on the B rail.
Step 3
Place the Isolated Neutral connector back into the two way slot shown below.
Step 4
Connect any Isolated trigger signals into the A rail as shown.
Step 5
Confirm that any Isolated Neutral connections have the Dip Switches in the TOP position.
Keywords
– Wiring the trigger
– Wiring the input
– Trigger
– Signal
– Isolated